ZSOM-Mini

The ZSOM-Mini is an off-the-shelf hardware module from NI Embedded-Specialty Alliance Member Schmid Elektronik, integrating the NI System-on-Module (SOM) sbRIO9651 on a tiny carrier board. It is designed for miniaturized measurement, control and monitoring applications and can be fully programmed with LabVIEW RT and LabVIEW FPGA. The board is about the size of the SOM itself and provides all the features on two screw terminals.

data sheet

• 6x analog in, 16 bit, ±5V or ±10V, 450kHz simultaneous, 4th order antialiasing with fg=200kHz.

• 10 x general purpose high speed I/O (DIO), configurable as digital input or output, 3.3V or 5V operation, speed in the MHz range allows to integrate high performance SPI devices. The SDK features VIs for the integration of digital busses like I2C and SPI
• 4x rugged digital input (DIN), 3-30V, OVP (DINX)
• 4x rugged open collector output (DOUT),max current: 200mA.

• 1x USB Host/TypeA
• 1x USB device/TypeC for TCP IP connection
• 1x CAN
• 1x SD-Card (available from hardware Version V1.1ff)
• 1x RS232
• 1x RS422/RS485
• 1x generic extension connector with possibility to add mPCIe board that adds WIFI, 4G and GPS to the system

• 1x reset button
• 4x status LED’s
• 1x 9 axes IMU
• 1x power on input (GO)
• 1x precise_rtc with wakeup functionality
• Power save mode with the Kill signal in the FPGA

• Pinout

Size including the SOM: 64mm x 76mm x 22mm

The following Versions are available:
ZSOM-Mini-BB-3S-ST-SE: Standard screw terminal version. Use this or ZSOM-Control to realize a prototype.
ZSOM-Mini-BB-1S-MP-SN: Embedded. Custom Base board and mechanical design needed.