Reset

The reset can be applied with the on board reset button and by pulling the reset input low, depending on the targets capabilities.

The STATUS_LED signal deasserts when the SYS_RST# signal asserts and remains deasserted until either five seconds have elapsed or the SYS_RST# signal deasserts. The STATUS_LED signal remains asserted until the operating system on the sbRIO-9651 SOM processor has loaded.

To reset the network settings follow the following steps:

1. Power the device
   1. Wait until the STATUS_LED gets dark.
   2. The device is in Run Mode
2. Press and hold the reset button
   1. Wait until the STATUS_LED gets dark again
3. Release the reset button
   1. Wait until the STATUS_LED gets dark again
   2. The device is in Safe mode
4. Press and hold the reset button
   1. Wait until the STATUS_LED gets dark again
5. Release the reset button
   1. Wait until the STATUS_LED gets dark again
   2. The device is in Safe mode with reset network settings