Zbrain System Z4 hw:dongles
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| hw:dongles [2014/04/14 14:48] – ba | hw:dongles [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 17: | Line 17: | ||
| \\ | \\ | ||
| Please read [[http:// | Please read [[http:// | ||
| - | Software documentation [[http:// | + | Software documentation: [[: |
| + | Software template/ | ||
| \\ | \\ | ||
| < | < | ||
| Line 36: | Line 37: | ||
| - order **ProgDongle_ZMC** for ZMC\\ | - order **ProgDongle_ZMC** for ZMC\\ | ||
| - If using FDM or JTAG, make sure the " | - If using FDM or JTAG, make sure the " | ||
| + | - The Flash Size is 64Mbit which is the size of the on board flash of Z27-C1 and half the size of the on board flash of ZMC and Z48-C1. | ||
| + | |||
| + | \\ | ||
| + | **BootJumper Settings for ProgDongle_STD: | ||
| + | {{: | ||
| + | 0E resistor, size 0603\\ | ||
| + | \\ | ||
| + | The boot jumper determines which memory the processor boots from:\\ | ||
| + | Not Set = boot from **target** memory (=normal boot mode)\\ | ||
| + | Set = boot from **ProgDongle** memory\\ | ||
| + | \\ | ||
| + | \\ | ||
| + | **R3 Settings for ProgDongle_ZMC: | ||
| + | {{: | ||
| + | 1k resistor, size 0603\\ | ||
| + | \\ | ||
| + | The resistor R3 determines which memory the processor boots from:\\ | ||
| + | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
| + | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
| + | |||
hw/dongles.1397479730.txt.gz · Last modified: 2017/11/07 22:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
