Zbrain System Z4 installation_checklist
This is an old revision of the document!
Table of Contents
Installation checklist Zbrain SDK Z4
Please follow this steps to check if the installation of Zbrain SDK Z4 was successful.
1. Check Com Ports
- start Zbrain SDK by double clicking the icon on the desktop
- go to the FDM tab
- Check if the COM port selector shows any com ports. (e.g. COM1).
- If the COM port selector doesn't show any at all, please install the VISA drivers
- Connect a ZMC via micro USB connector J6 to the PC. The USB driver should now install automatically on the PC.
- When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh.
- If the new com Port does not appear see issue 4000000D.
2. Check VisualDSP++
- go to the Run tab
- check if VisalDSP starts correctly by pressing this button:
installation_checklist.1360942900.txt.gz · Last modified: 2017/11/07 22:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
