This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
installation_checklist [2013/02/15 16:36] – ab | installation_checklist [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 4: | Line 4: | ||
- | ===== 1. Check Com Ports ===== | + | ==== 1. Check COM Ports ==== |
- start Zbrain SDK by double clicking the icon on the desktop | - start Zbrain SDK by double clicking the icon on the desktop | ||
- go to the FDM tab | - go to the FDM tab | ||
- Check if the COM port selector shows any com ports. (e.g. COM1). {{: | - Check if the COM port selector shows any com ports. (e.g. COM1). {{: | ||
- | - If the COM port selector | + | - If the COM port selector |
- | - Connect a [[ZMC]] via micro USB cable to the PC. | + | - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should |
- | - The USB driver should install | + | |
- When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | ||
- If the new com Port does not appear see [[issue400000d|issue 4000000D]]. | - If the new com Port does not appear see [[issue400000d|issue 4000000D]]. | ||
+ | \\ | ||
+ | ==== 2. Check VisualDSP++ ==== | ||
- | ===== VisualDSP++ ===== | ||
- | |||
- | - start The SDK | ||
- go to the Run tab | - go to the Run tab | ||
- | - start VisalDSP | + | - check if VisalDSP |