This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
hw:dongles [2014/05/21 14:58] – ab | hw:dongles [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 37: | Line 37: | ||
- order **ProgDongle_ZMC** for ZMC\\ | - order **ProgDongle_ZMC** for ZMC\\ | ||
- If using FDM or JTAG, make sure the " | - If using FDM or JTAG, make sure the " | ||
+ | - The Flash Size is 64Mbit which is the size of the on board flash of Z27-C1 and half the size of the on board flash of ZMC and Z48-C1. | ||
\\ | \\ | ||
Line 48: | Line 49: | ||
\\ | \\ | ||
\\ | \\ | ||
- | **BootJumper | + | **R3 Settings for ProgDongle_ZMC:**\\ |
- | {{:hw:progdonglejumper.png?80|}}\\ | + | {{:hw:progdongle_zmc_bootresistor.jpg?180|}}\\ |
- | 0E resistor, size 0603\\ | + | 1k resistor, size 0603\\ |
\\ | \\ | ||
The resistor R3 determines which memory the processor boots from:\\ | The resistor R3 determines which memory the processor boots from:\\ | ||
- | R3 = 1kOhm boot from **ProgDongle** memory\\ | ||
R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
+ | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
+ | |||