This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
hw:dongles [2014/04/24 08:27] – ab | hw:dongles [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 37: | Line 37: | ||
- order **ProgDongle_ZMC** for ZMC\\ | - order **ProgDongle_ZMC** for ZMC\\ | ||
- If using FDM or JTAG, make sure the " | - If using FDM or JTAG, make sure the " | ||
+ | - The Flash Size is 64Mbit which is the size of the on board flash of Z27-C1 and half the size of the on board flash of ZMC and Z48-C1. | ||
\\ | \\ | ||
- | **BootJumper Settings: | + | **BootJumper Settings |
{{: | {{: | ||
0E resistor, size 0603\\ | 0E resistor, size 0603\\ | ||
- | Set = boot from ProgDongle | + | \\ |
- | Not Set = boot from target memory (=normal boot mode) | + | The boot jumper determines which memory the processor boots from:\\ |
+ | Not Set = boot from **target** | ||
+ | Set = boot from **ProgDongle** memory\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | **R3 Settings for ProgDongle_ZMC: | ||
+ | {{: | ||
+ | 1k resistor, size 0603\\ | ||
+ | \\ | ||
+ | The resistor R3 determines which memory the processor boots from:\\ | ||
+ | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
+ | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
+ | |||