This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| progdongle_std [2012/03/23 14:14] – ab | progdongle_std [2013/05/27 17:56] – ba | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== ProgDongle ===== | ===== ProgDongle ===== | ||
| - | ZBrain-System(Z48-C1, | + | ZBrain-System (Z48-C1, Z27-C1) features a standard 2x8pin, 2mm pitch connector for programming.\\ |
| This connector features JTAG, FDM-UART and SPI-Bootlines.\\ | This connector features JTAG, FDM-UART and SPI-Bootlines.\\ | ||
| \\ | \\ | ||
| Line 7: | Line 7: | ||
| The ProgDongle serves several different functions: | The ProgDongle serves several different functions: | ||
| - | * FDM programming (RS232) | + | * FDM programming (RS232. Note: DSUB9 RS232 adapter cable needed) |
| * Emulator connection (JTAG) | * Emulator connection (JTAG) | ||
| * Series production and field updates (On board memory, boot and program from ProgDongle) | * Series production and field updates (On board memory, boot and program from ProgDongle) | ||
| Line 13: | Line 13: | ||
| {{: | {{: | ||
| + | |||
| + | |||
| + | {{: | ||
| \\ | \\ | ||
| + | **accessories needed:**\\ | ||
| + | - DSUB9 RS232 adapter cable for FDM programming\\ | ||
| + | |||
| \\ | \\ | ||
| - | **notes: | + | **notes:**\\ |
| - | - use ProgDongle_STD for Z48-C1, Z27-C1, custom hardware\\ | + | - order **ProgDongle_STD** for Z48-C1, Z27-C1 |
| - | - use ProgDongle_ZMC for ZMC\\ | + | - order **ProgDongle_ZMC** for ZMC\\ |
| - | - If using FDM or JTAG, make sure the " | + | - If using FDM or JTAG, make sure the " |
| - | set the " | + | |