No Boot

This page describes how the processor can be prevented from booting at power up to reconnect a VDSP-Session.
The processor remains in initial state and does not start any boot process at all.

Follow this steps:

  1. Connect the two pads together with a cable or something
  2. Apply power (or press RESET)
  3. Remove the cable, the processor remains in initial state
  4. Connect VDSP-Session



ZMC


Z48-C1


 
no_boot.txt · Last modified: 2017/11/07 22:26 by 127.0.0.1
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki