This is an old revision of the document!
In Mass Storage Device Mode (MSD) you can connect your ZBrain target to a computer and it will present itself as an external hard drive, like a USB-Stick.
Example:
1. Run the following code
2.connect the ZMC via USB cable to your PC
3.disconnect the USB cable to exit MSD-Mode.
(The board will automatically perform a softreset)
It is strongly recommended to use the latest interpreter. (at least firenze).
note:
- the NAND-Flash does not fully support Mass Storage Device
(Mass storage Device on NAND-Flash works only in FDM-Mode, which can be used e.g. to store graphics on the flash)