This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| emulators_and_debuggers [2011/08/05 07:03] – ba | emulators_and_debuggers [2011/08/06 17:27] – ba | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Emulators and Debuggers ====== | ====== Emulators and Debuggers ====== | ||
| - | Emulators are used to execute an application in realtime | + | Emulators are used to execute an application in realtime |
| + | They connect | ||
| \\ | \\ | ||
| Two options are available: | Two options are available: | ||
| Line 16: | Line 17: | ||
| See [[http:// | See [[http:// | ||
| </ | </ | ||
| + | \\ | ||
| :!: Do not physically reset your target or cycle power while a VisualDSP++ session is connected. \\ | :!: Do not physically reset your target or cycle power while a VisualDSP++ session is connected. \\ | ||
| Doing so may cause unexpected results and may cause your debug session to fail.\\ | Doing so may cause unexpected results and may cause your debug session to fail.\\ | ||
| Close the VisualDSP session before reseting the target.\\ | Close the VisualDSP session before reseting the target.\\ | ||
| \\ | \\ | ||
| - | Note:\\ | + | **Note:**\\ |
| - | - Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box. The dialog box is used to change the rate at which the JTAG runs. | + | - Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box.\\ |
| + | - Follow this steps to [[Creating_VDSP_Session|create a VisualDSP session]] | ||