This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
emulators_and_debuggers [2011/08/05 07:03] – ba | emulators_and_debuggers [2011/08/05 07:05] – ba | ||
---|---|---|---|
Line 16: | Line 16: | ||
See [[http:// | See [[http:// | ||
</ | </ | ||
+ | \\ | ||
:!: Do not physically reset your target or cycle power while a VisualDSP++ session is connected. \\ | :!: Do not physically reset your target or cycle power while a VisualDSP++ session is connected. \\ | ||
Doing so may cause unexpected results and may cause your debug session to fail.\\ | Doing so may cause unexpected results and may cause your debug session to fail.\\ | ||
Close the VisualDSP session before reseting the target.\\ | Close the VisualDSP session before reseting the target.\\ | ||
\\ | \\ | ||
- | Note:\\ | + | **Note:**\\ |
- | - Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box. The dialog box is used to change the rate at which the JTAG runs. | + | - Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box. |