[[convert_for_different_target]]
 
Trace:
You are here: start » convert_for_different_target

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
convert_for_different_target [2012/01/06 13:58] – abconvert_for_different_target [2012/01/06 13:59] – ab
Line 3: Line 3:
 Moving a project from one Zbrain Target to an other is done in two steps: Moving a project from one Zbrain Target to an other is done in two steps:
  
-  - Replace all refnums with refnums from the new target.\\ All Zbrain refnums are target bound. Replace them even if they have the same name and look the same (e.g. LED1 <-> LED1)  +  - Replace all refnums with refnums from the new target palette.\\ Note: all refnums are target specific. Replace them even if they have the same name and look the same (e.g. LED1 <-> LED1)  
   - Set the [[configure_target|Target configuration]]. Or you can generate a new project with the same vis for the new target. This sets the target configuration automatically.   - Set the [[configure_target|Target configuration]]. Or you can generate a new project with the same vis for the new target. This sets the target configuration automatically.
  
  
  
 
convert_for_different_target.txt · Last modified: 2017/11/07 22:26 by 127.0.0.1
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki