Convert a Project for a different Hardware Target

Moving a project from one Zbrain Target to an other is done in two steps:

  1. Replace all refnums with refnums from the new target palette.
    Note: all refnums are target specific. Replace them even if they have the same name and look the same (e.g. LED1 ↔ LED1)
  2. Set the Target configuration. Alternatively you can generate a new project with the same VIs for the new target.
    This sets the target configuration automatically.
convert_for_different_target.txt · Last modified: 2017/11/07 22:26 by
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki