This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| mass_storage_device [2012/05/10 08:45] – ab | mass_storage_device [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| \\ | \\ | ||
| \\ | \\ | ||
| - | Example:\\ | + | **Example:**\\ |
| 1. Run the following code\\ | 1. Run the following code\\ | ||
| - | {{: | + | {{: |
| \\ | \\ | ||
| 2.connect the [[ZMC]] via USB cable to your PC \\ | 2.connect the [[ZMC]] via USB cable to your PC \\ | ||
| Line 15: | Line 15: | ||
| (The board will automatically perform a softreset)\\ | (The board will automatically perform a softreset)\\ | ||
| \\ | \\ | ||
| - | :!: It is strongly recommended to use the latest | + | :!: **It is strongly recommended to use the latest |
| \\ | \\ | ||
| - | **note: | + | |
| - | - the [[nand_flash|NAND-Flash]] does not fully support Mass Storage Device\\ | + | |
| - | (Mass storage Device on NAND-Flash works only in FDM-Mode, which can be used e.g. to store graphics on the flash) | + | |