This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mass_storage_device [2012/05/10 08:45] – ab | mass_storage_device [2013/01/31 14:57] – ab | ||
---|---|---|---|
Line 7: | Line 7: | ||
Example:\\ | Example:\\ | ||
1. Run the following code\\ | 1. Run the following code\\ | ||
- | {{: | + | {{: |
\\ | \\ | ||
2.connect the [[ZMC]] via USB cable to your PC \\ | 2.connect the [[ZMC]] via USB cable to your PC \\ | ||
Line 15: | Line 15: | ||
(The board will automatically perform a softreset)\\ | (The board will automatically perform a softreset)\\ | ||
\\ | \\ | ||
- | :!: It is strongly recommended to use the latest interpreter. (at least firenze). | + | :!: It is strongly recommended to use the latest interpreter. |
\\ | \\ | ||
- | **note: | + | |
- | - the [[nand_flash|NAND-Flash]] does not fully support Mass Storage Device\\ | + | |
- | (Mass storage Device on NAND-Flash works only in FDM-Mode, which can be used e.g. to store graphics on the flash) | + | |