This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mass_storage_device [2011/12/08 08:45] – ab | mass_storage_device [2013/01/31 14:59] – ab | ||
---|---|---|---|
Line 2: | Line 2: | ||
\\ | \\ | ||
- | In Mass Storage Device Mode (MSD) you can connect your ZBrain target to a computer and it will present itself as an external hard drive, like a USB-Stick. | + | In USB - Mass Storage Device Mode (MSD) you can connect your ZBrain target to a computer and it will present itself as an external hard drive, like a USB-Stick. |
\\ | \\ | ||
\\ | \\ | ||
- | Example:\\ | + | **Example:**\\ |
1. Run the following code\\ | 1. Run the following code\\ | ||
- | {{: | + | {{: |
\\ | \\ | ||
2.connect the [[ZMC]] via USB cable to your PC \\ | 2.connect the [[ZMC]] via USB cable to your PC \\ | ||
{{: | {{: | ||
\\ | \\ | ||
- | 3.disconnect the USB cable to exit USB-Mode.\\ | + | 3.disconnect the USB cable to exit MSD-Mode.\\ |
- | (The board will automatically | + | (The board will automatically |
\\ | \\ | ||
- | :!: It is strongly recommended to use the latest | + | :!: It is strongly recommended to use the latest |
\\ | \\ | ||
- | **note: | + | |
- | - the [[nand_flash|NAND-Flash]] does not fully support Mass Storage Device\\ | + | |
- | (Mass storage Device on NAND-Flash works only in FDM-Mode, which can be used e.g. to store graphics on the flash) | + | |