This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mass_storage_device [2011/11/22 10:52] – ba | mass_storage_device [2013/01/31 14:58] – ab | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| \\ | \\ | ||
| - | In Mass Storage Device Mode (MSD) you can connect your ZBrain target to a computer and it will present itself as an external hard drive, like a USB-Stick. | + | In USB - Mass Storage Device Mode (MSD) you can connect your ZBrain target to a computer and it will present itself as an external hard drive, like a USB-Stick. |
| \\ | \\ | ||
| \\ | \\ | ||
| - | Example:\\ | + | **Example:**\\ |
| 1. Run the following code\\ | 1. Run the following code\\ | ||
| - | {{: | + | {{: |
| \\ | \\ | ||
| 2.connect the [[ZMC]] via USB cable to your PC \\ | 2.connect the [[ZMC]] via USB cable to your PC \\ | ||
| {{: | {{: | ||
| - | + | \\ | |
| - | + | 3.disconnect the USB cable to exit MSD-Mode.\\ | |
| - | :!: It is strongly recommended, that you have the latest interpreter | + | (The board will automatically perform a softreset)\\ |
| + | \\ | ||
| + | :!: It is strongly recommended | ||
| \\ | \\ | ||
| - | **note: | + | |
| - | - the [[nand_flash|NAND-Flash]] does not fully support Mass Storage Device\\ | + | |
| - | Mass storage Device on NAND-Flash works only in FMD-Mode, which can be used e.g. to store graphics on the flash. | + | |