This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mass_storage_device [2011/11/22 10:52] – ba | mass_storage_device [2011/12/08 08:46] – ab | ||
---|---|---|---|
Line 7: | Line 7: | ||
Example:\\ | Example:\\ | ||
1. Run the following code\\ | 1. Run the following code\\ | ||
- | {{: | + | {{: |
\\ | \\ | ||
2.connect the [[ZMC]] via USB cable to your PC \\ | 2.connect the [[ZMC]] via USB cable to your PC \\ | ||
{{: | {{: | ||
- | + | \\ | |
- | + | 3.disconnect the USB cable to exit USB-Mode.\\ | |
- | :!: It is strongly recommended, that you have the latest interpreter | + | (The board will automatically perform a softreset)\\ |
+ | \\ | ||
+ | :!: It is strongly recommended | ||
\\ | \\ | ||
**note:**\\ | **note:**\\ | ||
- the [[nand_flash|NAND-Flash]] does not fully support Mass Storage Device\\ | - the [[nand_flash|NAND-Flash]] does not fully support Mass Storage Device\\ | ||
- | Mass storage Device on NAND-Flash works only in FMD-Mode, which can be used e.g. to store graphics on the flash. | + | (Mass storage Device on NAND-Flash works only in FDM-Mode, which can be used e.g. to store graphics on the flash) |