This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| emulators_and_debuggers [2011/08/05 07:00] – ba | emulators_and_debuggers [2011/08/05 07:03] – ba | ||
|---|---|---|---|
| Line 17: | Line 17: | ||
| </ | </ | ||
| - | :!: Do not physically reset your target or cycle power while VisualDSP++ is connected | + | :!: Do not physically reset your target or cycle power while a VisualDSP++ |
| - | Doing so may cause unexpected results and may cause your debug session to fail. | + | Doing so may cause unexpected results and may cause your debug session to fail.\\ |
| - | + | Close the VisualDSP session before reseting | |
| - | Physically unplugging is not necessary to reset or power cycle the target. | + | \\ |
| - | + | Note:\\ | |
| - | 1) Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box. The dialog box is used to change the rate at which the JTAG runs. | + | - Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box. The dialog box is used to change the rate at which the JTAG runs. |