Table of Contents

Trouble shooting

Trouble Shooting Cheat Sheet

Symptoms Possible Reason Mitigation Strategy Targets
Power LED dark or Status LED dark when powered up Insufficient power supplied Check requirements
The Status LED normally goes dark after a few seconds
All
Target not woken up Activate trough power on input (GO) ZSOM-Mini
RTC Alarm occurred when Target was still running or when no power was supplied. Remove backup battery ZSOM-Mini V1.1
(fixed on V1.2)
Target defect Contact Schmid Elektronik AG All
Status LED is flashing sbRIO9651 is not in standard mode See Status LED All
Project cannot connect to the Target IP Address configured in the project does not match the IP address of the target To discover or change the IP address of you Target see the ethernet page. All

If nothing helps

Contact us on tech.support@schmid-elektronik.ch