This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
z3z4_migration_guide [2013/05/16 12:55] – ba | z3z4_migration_guide [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 6: | Line 6: | ||
- Copy all Sub VI's from the old Z3 project into the newly generated " | - Copy all Sub VI's from the old Z3 project into the newly generated " | ||
- Copy the old main VI into the the new project folder | - Copy the old main VI into the the new project folder | ||
- | - Make sure the old main VI has the [[vi_prototype_mismatch|standard connector pane]]: {{: | ||
- Rename main VI (optional) | - Rename main VI (optional) | ||
+ | - Make sure the main VI has the [[vi_prototype_mismatch|standard connector pane]]: {{: | ||
- Start a mass compile under Tools-> | - Start a mass compile under Tools-> | ||
- In Zbrain SDK select the new main VI | - In Zbrain SDK select the new main VI | ||
- | ===== Necessary software adaptions===== | + | ===== Necessary software adaptions |
- | - Replace LabVIEW file functions with z-file functions.\\ (Replace pathes with strings) | + | - Replace LabVIEW |
- | - Replace LabVIEW ethernet VIs with z-ethernet VI's | + | - Replace LabVIEW |
- | - Replace LabVIEW timing VI's (e.g. "to time stamp" | + | - Replace LabVIEW |
- | - Parallel loops must be replaced by single loops | + | - **Parallel loops** must be replaced by a single |
+ | - Make sure all controls& | ||
===== Hints ===== | ===== Hints ===== | ||
* Check the yellow exclamation mark for unsupported VIs | * Check the yellow exclamation mark for unsupported VIs | ||
- | * When working with Z3 and Z4 follow this instructions: | + | * To switch between |