Zbrain System Z4 snippets:no_boot
This is an old revision of the document!
No Boot
This page describes how the processor can be prevented from booting at power up to reconnect a VDSP-Session.
The processor remains in initial state and does not start any boot process at all.
Follow this steps:
- Connect the two pads together with a cable or something
- Apply power (or press RESET)
- Remove the cable, the processor remains in initial state
- Connect VDSP-Session
ZMC
Z48-C1
snippets/no_boot.1398757026.txt.gz · Last modified: 2017/11/07 22:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
