This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
installation_checklist [2013/02/15 16:43] – ab | installation_checklist [2013/02/15 17:49] – ab | ||
---|---|---|---|
Line 9: | Line 9: | ||
- go to the FDM tab | - go to the FDM tab | ||
- Check if the COM port selector shows any com ports. (e.g. COM1). {{: | - Check if the COM port selector shows any com ports. (e.g. COM1). {{: | ||
- | - If the COM port selector | + | - If the COM port selector |
- Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically. This process might take some minutes. | - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically. This process might take some minutes. | ||
- When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. |