Zbrain System Z4 installation_checklist
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| installation_checklist [2013/02/15 16:41] – ab | installation_checklist [2013/02/15 17:49] – ab | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| - go to the FDM tab | - go to the FDM tab | ||
| - Check if the COM port selector shows any com ports. (e.g. COM1). {{: | - Check if the COM port selector shows any com ports. (e.g. COM1). {{: | ||
| - | - If the COM port selector | + | - If the COM port selector |
| - | - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically | + | - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically. This process might take some minutes. |
| - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | ||
| - If the new com Port does not appear see [[issue400000d|issue 4000000D]]. | - If the new com Port does not appear see [[issue400000d|issue 4000000D]]. | ||
| + | \\ | ||
| ==== 2. Check VisualDSP++ ==== | ==== 2. Check VisualDSP++ ==== | ||
installation_checklist.txt · Last modified: 2017/11/07 22:26 by 127.0.0.1
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
