This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
hw:dongles [2014/04/24 08:29] – ab | hw:dongles [2015/07/06 11:42] – ba | ||
---|---|---|---|
Line 37: | Line 37: | ||
- order **ProgDongle_ZMC** for ZMC\\ | - order **ProgDongle_ZMC** for ZMC\\ | ||
- If using FDM or JTAG, make sure the " | - If using FDM or JTAG, make sure the " | ||
+ | - The Flash Size is 64Mbit which is the size of the on board flash of Z27-C1 and half the size of the on board flash of ZMC and Z48-C1. | ||
\\ | \\ | ||
- | **BootJumper Settings: | + | **BootJumper Settings |
{{: | {{: | ||
0E resistor, size 0603\\ | 0E resistor, size 0603\\ | ||
Line 46: | Line 47: | ||
Not Set = boot from **target** memory (=normal boot mode)\\ | Not Set = boot from **target** memory (=normal boot mode)\\ | ||
Set = boot from **ProgDongle** memory\\ | Set = boot from **ProgDongle** memory\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | **R3 Settings for ProgDongle_ZMC: | ||
+ | {{: | ||
+ | 1k resistor, size 0603\\ | ||
+ | \\ | ||
+ | The resistor R3 determines which memory the processor boots from:\\ | ||
+ | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
+ | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
+ | |||