This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
hw:dongles [2014/04/14 16:36] – ba | hw:dongles [2015/07/06 11:42] – ba | ||
---|---|---|---|
Line 17: | Line 17: | ||
\\ | \\ | ||
Please read [[http:// | Please read [[http:// | ||
- | Software documentation: | + | Software documentation: |
- | A application that was built to boot from ProgDongle that performs firmware update and more can be downloaded from the [[templates| templates page]].\\ | + | Software template/ |
\\ | \\ | ||
< | < | ||
Line 37: | Line 37: | ||
- order **ProgDongle_ZMC** for ZMC\\ | - order **ProgDongle_ZMC** for ZMC\\ | ||
- If using FDM or JTAG, make sure the " | - If using FDM or JTAG, make sure the " | ||
+ | - The Flash Size is 64Mbit which is the size of the on board flash of Z27-C1 and half the size of the on board flash of ZMC and Z48-C1. | ||
+ | |||
+ | \\ | ||
+ | **BootJumper Settings for ProgDongle_STD: | ||
+ | {{: | ||
+ | 0E resistor, size 0603\\ | ||
+ | \\ | ||
+ | The boot jumper determines which memory the processor boots from:\\ | ||
+ | Not Set = boot from **target** memory (=normal boot mode)\\ | ||
+ | Set = boot from **ProgDongle** memory\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | **R3 Settings for ProgDongle_ZMC: | ||
+ | {{: | ||
+ | 1k resistor, size 0603\\ | ||
+ | \\ | ||
+ | The resistor R3 determines which memory the processor boots from:\\ | ||
+ | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
+ | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
+ | |||