This is an old revision of the document!
Emulators are used to execute an application in realtime using VisualDSP.
They connect to the target via JTAG connector.
Two options are available:
High performance emulator HP-USB-ICE |
Low Cost debugger ICE 1000 |
Low Cost debugger ICE 100-B |
Do not physically reset your target or cycle power while a VisualDSP++ session is connected.
Doing so may cause unexpected results and may cause your debug session to fail.
Close the VisualDSP session before reseting the target.
Note:
- Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box.