Zbrain System Z4 hw:dongles
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| hw:dongles [2014/05/21 14:59] – ab | hw:dongles [2014/05/21 15:06] – ab | ||
|---|---|---|---|
| Line 48: | Line 48: | ||
| \\ | \\ | ||
| \\ | \\ | ||
| - | **BootJumper | + | **R3 Settings for ProgDongle_ZMC: |
| - | {{:hw:progdonglejumper.png?80|}}\\ | + | {{:hw:progdongle_zmc_bootresistor.jpg?180|}}\\ |
| 1k resistor, size 0603\\ | 1k resistor, size 0603\\ | ||
| \\ | \\ | ||
| The resistor R3 determines which memory the processor boots from:\\ | The resistor R3 determines which memory the processor boots from:\\ | ||
| - | R3 = 1kOhm boot from **ProgDongle** memory\\ | ||
| R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
| + | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
| + | |||
hw/dongles.txt · Last modified: 2017/11/07 22:26 by 127.0.0.1
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
