This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hw:dongles [2014/04/24 08:25] – ab | hw:dongles [2014/05/21 15:06] – ab | ||
---|---|---|---|
Line 39: | Line 39: | ||
\\ | \\ | ||
- | **BootJumper Settings: | + | **BootJumper Settings |
{{: | {{: | ||
0E resistor, size 0603\\ | 0E resistor, size 0603\\ | ||
- | Set = Boot From Dongle\\ | + | \\ |
- | Not Set = normal | + | The boot jumper determines which memory the processor boots from:\\ |
+ | Not Set = boot from **target** memory | ||
+ | Set = boot from **ProgDongle** memory\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | **R3 Settings for ProgDongle_ZMC: | ||
+ | {{: | ||
+ | 1k resistor, size 0603\\ | ||
+ | \\ | ||
+ | The resistor R3 determines which memory the processor boots from:\\ | ||
+ | R3 = not assembled = boot from **target** memory (=normal boot mode)\\ | ||
+ | R3 = 1kOhm = boot from **ProgDongle** memory\\ | ||
+ | |||