This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
emulators_and_debuggers [2016/06/21 15:37] – ba | emulators_and_debuggers [2016/06/21 15:56] – ba | ||
---|---|---|---|
Line 2: | Line 2: | ||
Emulators are used to execute an application in realtime using VisualDSP.\\ | Emulators are used to execute an application in realtime using VisualDSP.\\ | ||
They connect to the target via JTAG connector.\\ | They connect to the target via JTAG connector.\\ | ||
- | \\ | + | |
Two options are available: | Two options are available: | ||
< | < | ||
Line 10: | Line 10: | ||
[[debugging_in_visualdsp# | [[debugging_in_visualdsp# | ||
See [[http:// | See [[http:// | ||
+ | < | ||
+ | **Low Cost debugger ICE 1000**\\ | ||
+ | {{: | ||
+ | Load executables slower (255 KB/sec)\\ | ||
+ | [[debugging_in_visualdsp# | ||
+ | See [[http:// | ||
< | < | ||
**Low Cost debugger ICE 100-B**\\ | **Low Cost debugger ICE 100-B**\\ | ||
Line 15: | Line 21: | ||
Load executables slower (255 KB/sec)\\ | Load executables slower (255 KB/sec)\\ | ||
[[debugging_in_visualdsp# | [[debugging_in_visualdsp# | ||
- | See [[http:// | + | This Debugger is no mor available\\ |
</ | </ | ||
\\ | \\ | ||
Line 24: | Line 30: | ||
**Note:**\\ | **Note:**\\ | ||
- Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box.\\ | - Choosing the JTAG Frequency Selection from the Settings menu in VisualDSP++ opens the JTAG Frequency Selection dialog box.\\ | ||
- | - Follow this steps to [[Creating_VDSP_Session|create a VisualDSP session]] | + | |