This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
setspeed [2011/04/29 10:52] – created ab | setspeed [2011/06/20 10:18] – ab | ||
---|---|---|---|
Line 4: | Line 4: | ||
\\ | \\ | ||
** Notes about debugging: **\\ | ** Notes about debugging: **\\ | ||
- | * After changing the clock speed debugging gets complicated. Thus start to work on clock changes only at the very end of a development cycle | + | * Debugging gets complicated after changing the clock speed. Thus its recommended |
- | * After changing the clock speed the emulator looses connection to the target. For this reason it's important never to change the clockspeed | + | * After changing the clock speed the emulator looses connection to the target. For this reason it's important |
- | * The program | + | * The program |
- | * To reconnect to the target, | + | |
+ | \\ | ||
+ | \\ | ||
+ | ** No Boot **\\ | ||
+ | In case the VDSP session cannot be connected because a flashed application changes the clock settings, follow this instructions: | ||
+ | [[no_boot]] |