Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
ethernet_how_to [2011/01/28 10:30] baethernet_how_to [2011/01/28 10:33] – [Project settings] ba
Line 6: Line 6:
 The section //Set IP address programmatically// below shows how IP address is set with dynamic configuration. \\ The section //Set IP address programmatically// below shows how IP address is set with dynamic configuration. \\
 **fix configuration** \\ **fix configuration** \\
-If you set any other IP address or enable [[wp>DHCP]] support, the Ethernet component will be started before any VI is executed. This leads to longer boot time and can block the program (when no network is connected) before a watchdog can be set up or a life sign can be given out. The settings (IP adress, gateway, MAC address...) cannot be chaneg at runtime.\\+If you set any other IP address or enable [[wp>DHCP]] support, the Ethernet component will be started before any VI is executed. This leads to longer boot time and can block the program (when no network is connected) before a watchdog can be set up or a life sign can be given out. The settings (IP adress, gateway, MAC address...) cannot be changed at runtime.\\
  
 You will get the error **Failed to open the lan-device** in the VisualDSP++ console output if you use programmatic IP configuration with fix configuration.\\ You will get the error **Failed to open the lan-device** in the VisualDSP++ console output if you use programmatic IP configuration with fix configuration.\\
 
ethernet_how_to.txt · Last modified: 2017/11/07 22:26 by 127.0.0.1
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki