[[ethernet_how_to]]
 
Trace:
You are here: start » ethernet_how_to

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
ethernet_how_to [2011/01/28 10:16] – [Project settings] baethernet_how_to [2011/01/28 10:29] – ba
Line 13: Line 13:
 {{:snippets:ethernet_start_up.png|Start up Ethernet with Labview on Microprocessor}} drag and drop this [[VI snippet]] into a LabVIEW block diagram.\\ {{:snippets:ethernet_start_up.png|Start up Ethernet with Labview on Microprocessor}} drag and drop this [[VI snippet]] into a LabVIEW block diagram.\\
 In version 3.2.1 a [[MAC address workaround|workaround]] is needed to enable a correct setting of the MAC address.  In version 3.2.1 a [[MAC address workaround|workaround]] is needed to enable a correct setting of the MAC address. 
-===== UDP example ===== +===== Protocolls ===== 
-A UDP master slave connection can be implemented as shown in the two snippets below:\\ +  * [[UDP example]]
- +
-Slave communications loop. (can run on the PC or on a a Zsystem hardware platform.)\\ +
-{{:snippets:udp_comm_slave_loop_embedded.png|UDP Slave snippet}}drag and drop this [[VI snippet]] into a LabVIEW block diagram.\\ +
- +
-Master loop. (Can run on a PC.)\\ +
-{{:snippets:udp_comm_master_loop.png|UDP master snippet}}drag and drop this [[VI snippet]] into a LabVIEW block diagram.\\ +
  
 
ethernet_how_to.txt · Last modified: 2017/11/07 22:26 by 127.0.0.1
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki