Differences

This shows you the differences between two versions of the page.

--- ethernet_how_to [2011/01/28 10:14] – [Project settings] ba
+++ ethernet_how_to [2011/01/28 10:16] – [Project settings] ba
@@ Line 6: / Line 6: @@
 The section //Set IP address programmatically// below shows how IP address is set with dynamic configuration. \\
 **fix configuration** \\
-If you set any other IP address or enable [[wp>DHCP]] support, the Ethernet component will be started before any VI is executed. This leads to longer boot time and can block the program (when no network is connected) before a watchdog can be set up or a life sign can be given out. The settings (IP adress, gateway, MAC address...) cannot be chaneg at runtime.
+If you set any other IP address or enable [[wp>DHCP]] support, the Ethernet component will be started before any VI is executed. This leads to longer boot time and can block the program (when no network is connected) before a watchdog can be set up or a life sign can be given out. The settings (IP adress, gateway, MAC address...) cannot be chaneg at runtime.\\
+You will get the error **Failed to open the lan-device** in the VisualDSP++ console output if you use programmatic IP configuration with fix configuration.\\
 ===== Set IP address programmatically =====
 From [[SDK]] version 3.2.1 empoli SP1 the IP Address, Subnet Mask, Gateway and MAC address can be set in the program at the start of th Ethernet component.\\