Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
| ethernet_how_to [2011/01/28 10:12] – [Project settings] ba | ethernet_how_to [2011/01/28 10:13] – [Project settings] ba |
|---|
| ===== Project settings ===== | ===== Project settings ===== |
| **dynamic configuration** \\ | **dynamic configuration** \\ |
| In the //Communication// options tab of the //[[build specifications]]// set the check mark //Enable lwIP TCP/IP support//. | In the //Communication// options tab of the //[[build specifications]]// set the check mark //Enable lwIP TCP/IP support//. \\ |
| Set the IP address to 7.7.7.7 \\ | Set the IP address to 7.7.7.7 \\ |
| | The section //Set IP address programmatically// below shows how IP address is set with dynamic configuration. |
| **fix configuration** \\ | **fix configuration** \\ |
| If you set any other IP address or enable [[wp>DHCP]] support, the Ethernet component will be started before any VI is executed. This leads to longer boot time and can block the program (when no network is connected) before a watchdog can be set up or a life sign can be given out. The settings (IP adress, gateway, MAC address...) cannot be chaneg at runtime. | If you set any other IP address or enable [[wp>DHCP]] support, the Ethernet component will be started before any VI is executed. This leads to longer boot time and can block the program (when no network is connected) before a watchdog can be set up or a life sign can be given out. The settings (IP adress, gateway, MAC address...) cannot be chaneg at runtime. |
