Zbrain System Z4 installation_checklist
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| installation_checklist [2013/02/15 16:43] – ab | installation_checklist [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| - go to the FDM tab | - go to the FDM tab | ||
| - Check if the COM port selector shows any com ports. (e.g. COM1). {{: | - Check if the COM port selector shows any com ports. (e.g. COM1). {{: | ||
| - | - If the COM port selector | + | - If the COM port selector |
| - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically. This process might take some minutes. | - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically. This process might take some minutes. | ||
| - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh. | ||
installation_checklist.1360943005.txt.gz · Last modified: 2017/11/07 22:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
