Differences

This shows you the differences between two versions of the page.

--- installation_checklist [2013/02/15 16:36] – ab
+++ installation_checklist [2017/11/07 22:26] (current) – external edit 127.0.0.1
@@ Line 4: / Line 4: @@
-===== 1. Check Com Ports =====
+==== 1. Check COM Ports ====
   - start Zbrain SDK by double clicking the icon on the desktop
   - go to the FDM tab
   - Check if the COM port selector shows any com ports. (e.g. COM1). {{:toolchain:sdk:sdk_fdm_comport.png?direct|}}
-  - If the COM port selector   doesn't show any at all, please [[issue4000007|install the VISA drivers]]
+  - If the COM port selector   doesn't show any ports at all, please [[issue4000007|install the VISA drivers]]
-  - Connect a [[ZMC]] via micro USB cable to the PC.
+  - Connect a [[ZMC]] via **micro USB connector J6** to the PC. The USB driver should now install automatically. This process might take some minutes.
-  - The USB driver should install automatic.
   - When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh.
   - If the new com Port does not appear see [[issue400000d|issue 4000000D]].
+\\
+==== 2. Check VisualDSP++ ====
-===== VisualDSP++ =====
-  - start The SDK
   - go to the Run tab
-  - start VisalDSP with this button: {{:toolchain:sdk:sdk_run_connect.png?direct|}}
+  - check if VisalDSP starts correctly by pressing this button: {{:toolchain:sdk:sdk_run_connect.png?direct|}}

Zbrain System Z4 WIKI