Zbrain System Z4 install_ftdi
This is an old revision of the document!
Manually install FTDI driver
The FTDI USB driver provides a virtual COM port when the ZMC board is connected to the computer .
On some computers (x64), it is necessary to manually install the FTDI driver.
You can check if the driver is installed correctly with the installation checklist.
To install the driver
- goto <LabVIEW 2011 installation folder>\Targets\Schmid\FTDI\
- enter the folder matching your system (32bit or 64 bit)
- run dpinst.exe
install_ftdi.1360947618.txt.gz · Last modified: 2017/11/07 22:26 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
