Differences

This shows you the differences between two versions of the page.

--- install_ftdi [2013/02/13 12:12] – created ba
+++ install_ftdi [2017/11/07 22:26] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-====== Install FTDI driver by hand ======
+====== Manually install FTDI driver ======
+The FTDI USB driver provides a virtual COM port when the [[ZMC]] board is connected to the computer via mini USB J6.\\
-On some computers, it is necessary to install the FTDI driver by hand.
+On some computers (x64), it is necessary to manually install the FTDI driver.
-You can check if the driver is installed correctly with the [[installation_checklist|installation checklist]].
+You can check if the driver is installed correctly by following the [[installation_checklist|installation checklist]].
 To install the driver
   - goto <LabVIEW 2011 installation folder>\Targets\Schmid\FTDI\
-  - enter the folder matching your system (32bit or 64 bit)
+  - open the folder matching your system (32bit or 64 bit)
   - run dpinst.exe

Zbrain System Z4 WIKI