Table of Contents
Installation checklist Zbrain SDK Z4
1. Check COM Ports
2. Check VisualDSP++
Installation checklist Zbrain SDK Z4
Please follow this steps to check if the installation of Zbrain SDK Z4 was successful.
1. Check COM Ports
start Zbrain SDK by double clicking the icon on the desktop
go to the FDM tab
Check if the COM port selector shows any com ports. (e.g. COM1).
If the COM port selector doesn't show any ports at all, please
install the VISA drivers
Connect a
ZMC
via
micro USB connector J6
to the PC. The USB driver should now install automatically. This process might take some minutes.
When the driver is successfully installed, a new com port appears in the COM port selector after executing a refresh.
If the new com Port does not appear see
issue 4000000D
.
2. Check VisualDSP++
go to the Run tab
check if VisalDSP starts correctly by pressing this button: