This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
labview_embedded_programming_style_guide [2011/04/21 13:24] – ab | labview_embedded_programming_style_guide [2011/08/05 04:24] – ba | ||
---|---|---|---|
Line 4: | Line 4: | ||
===== general design approach ===== | ===== general design approach ===== | ||
* Only do small development steps at a time! \\ Remember, while working in FDM mode the code is executed on the PC and not on the target. Timing is different and VIs might execute different. | * Only do small development steps at a time! \\ Remember, while working in FDM mode the code is executed on the PC and not on the target. Timing is different and VIs might execute different. | ||
- | * For this reason its absolutely crucial that only small pieces of code are developed in FDM mode, then compiled and tested in real time on the target | + | |
* DO NOT use the LabVIEW " | * DO NOT use the LabVIEW " | ||