no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== Flash a loader file manually ======
+This site describes how to burn a loader file **(*.ldr)** into the target FLASH memory.\\
+From Version Firenze on there is a [[flash_a_application|flashing application]] in the kick starter.
+\\
+The *.ldr file can either be:\\
+- your application *.ldr file\\
+- the FDM-Interpreter *.ldr file
+\\
+\\
+**1. Open Visual DSP++**\\
+\\
+**2. Connect to the target**\\
+{{:toolchain:connect.png|}}\\
+\\
+**3. Start the Flash Programmer**\\
+choose Tools -> Flash Programmer.. from the menu:\\
+{{:toolchain:start_flash_programmer.png|}}\\
+\\
+**4. Select flash driver**\\
+{{:toolchain:load_driver.png|}}\\
+Browse to the driver or copy paste the path from the Loader File Generator window.\\
+The path might look like this: C:\Program Files\National Instruments\LabVIEW 2009\Targets\Schmid\Embedded\ZRefMnC\FlashDriver_ZRefMnC.dxe\\
+\\
+**5. Press "load driver"**\\
+\\
+**6. Select the Loader file**\\
+On the second tab of the Flash driver utility you can define the *.ldr file that is to be burned to the target.\\
+\\
+Choose either the *.ldr file of your application, or\\
+burn the FDM-Interpreter <code><LabVIEW Directory>\Targets\Schmid\Embedded\<target>\interpreter<version>.ldr</code> into the target.
+The specific path might look like this:
+C:\Program Files\National Instruments\LabVIEW 2009\Targets\Schmid\Embedded\ZRefMnC\interpreterd_V3.2.1_empoli_SP1.ldr\\
+\\
+**7. Flash it**\\
+Check the settings and press "program"\\
+{{:toolchain:flash.png|}}\\
+\\
+**8. Success**\\
+If you get the message that the application has flashed correctly, click OK and disconnect from the target.
+Execute a power cycle or press the reset button to get the recently flased application running.\\
+Note:\\
+For Blackfin BF548 targets this process takes between 2..6minutes, for a Blackfin BF527 target 4..25minutes.