This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
ethernet_how_to [2011/02/23 15:25] – ba | ethernet_how_to [2017/11/07 22:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Ethernet How To ====== | ====== Ethernet How To ====== | ||
- | **We recommend to use UDP instead of TCP** if possible. | + | **We recommend to use UDP instead of TCP** if possible. |
===== Project settings ===== | ===== Project settings ===== | ||
**dynamic configuration** \\ | **dynamic configuration** \\ | ||
Line 12: | Line 12: | ||
===== Set IP address programmatically ===== | ===== Set IP address programmatically ===== | ||
From [[SDK]] version 3.2.1 empoli SP1 the IP Address, Subnet Mask, Gateway and MAC address can be set in the program at the start of th Ethernet component.\\ | From [[SDK]] version 3.2.1 empoli SP1 the IP Address, Subnet Mask, Gateway and MAC address can be set in the program at the start of th Ethernet component.\\ | ||
- | {{: | + | {{: |
+ | drag and drop this [[VI snippet]] into a LabVIEW block diagram.\\ | ||
In version 3.2.1 a [[MAC address workaround|workaround]] is needed to enable a correct setting of the MAC address. | In version 3.2.1 a [[MAC address workaround|workaround]] is needed to enable a correct setting of the MAC address. | ||
===== Protocolls ===== | ===== Protocolls ===== |