This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| ethernet_how_to [2011/02/23 15:25] – ba | ethernet_how_to [2011/03/16 16:38] – ab | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Ethernet How To ====== | ====== Ethernet How To ====== | ||
| - | **We recommend to use UDP instead of TCP** if possible. | + | **We recommend to use UDP instead of TCP** if possible. |
| ===== Project settings ===== | ===== Project settings ===== | ||
| **dynamic configuration** \\ | **dynamic configuration** \\ | ||
| Line 12: | Line 12: | ||
| ===== Set IP address programmatically ===== | ===== Set IP address programmatically ===== | ||
| From [[SDK]] version 3.2.1 empoli SP1 the IP Address, Subnet Mask, Gateway and MAC address can be set in the program at the start of th Ethernet component.\\ | From [[SDK]] version 3.2.1 empoli SP1 the IP Address, Subnet Mask, Gateway and MAC address can be set in the program at the start of th Ethernet component.\\ | ||
| - | {{: | + | {{: |
| + | drag and drop this [[VI snippet]] into a LabVIEW block diagram.\\ | ||
| In version 3.2.1 a [[MAC address workaround|workaround]] is needed to enable a correct setting of the MAC address. | In version 3.2.1 a [[MAC address workaround|workaround]] is needed to enable a correct setting of the MAC address. | ||
| ===== Protocolls ===== | ===== Protocolls ===== | ||