zsom:reset

Reset

The reset can be applied with the on board reset button and by pulling the reset input low, depending on the targets capabilities.

The STATUS_LED signal deasserts when the SYS_RST# signal asserts and remains deasserted until either five seconds have elapsed or the SYS_RST# signal deasserts. The STATUS_LED signal remains asserted until the operating system on the sbRIO-9651 SOM processor has loaded.

To reset the network settings follow the following steps:

  1. Power the device
    1. Wait until the STATUS_LED gets dark.
    2. The device is in Run Mode
  2. Press and hold the reset button
    1. Wait until the STATUS_LED gets dark again
  3. Release the reset button
    1. Wait until the STATUS_LED gets dark again
    2. The device is in Safe mode
  4. Press and hold the reset button
    1. Wait until the STATUS_LED gets dark again
  5. Release the reset button
    1. Wait until the STATUS_LED gets dark again
    2. The device is in Safe mode with reset network settings
  • Last modified: 3 years ago