zsom:mini:zsom_mini

This is an old revision of the document!


ZSOM-Mini

The ZSOM-Mini is an off-the-shelf hardware module from NI Embedded-Specialty Alliance Member Schmid Elektronik, integrating the NI System-on-Module (SOM) sbRIO9651 on a tiny carrier board. It is designed for miniaturized measurement, control and monitoring applications and can be fully programmed with LabVIEW RT and LabVIEW FPGA. The board is about the size of the SOM itself and provides all the features on two screw terminals.

data sheet

  • 6x analog in, 16 bit, ±5V or ±10V, 450kHz simultaneous, 4th order antialiasing with fg=200kHz.
  • 1x USB Host/TypeA
  • 1x USB device/TypeC for TCP IP connection
  • 1x CAN
  • 1x SD-Card (available from hardware Version V1.1ff)
  • 1x RS232
  • 1x generic extension connector with possibility to add mPCIe board that adds WIFI, 4G and GPS to the system

Size including the SOM: 64mm x 76mm x 22mm

ZSOM-Mini-xx - xx - xx - xx
Heat spreader SE Schmid Elektronik
NH No Heat Spreader
SN Schmid elektronik (No top sheet metal)
Connection ST Screw Terminal
MP Multi Pin Connector (Stiftleiste)
00 Solder Pads
Power concept 3S Multi cell battery or power supply (9…30V)
1S Single cell battery (3.5..4.2V)
Backup Voltage BB Backup Battery
NB No Backup Battery
BH Backup Battery for external RTC only

The following Versions are available:
ZSOM-Mini-BB-3S-ST-SE: Standard screw terminal version. Use this or ZSOM-Control to realize a prototype.
ZSOM-Mini-BB-1S-MP-SN: Embedded. Custom Base board and mechanical design needed.

  • Last modified: 2 years ago