Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
status_leds [2019/06/05 09:28]
ba
status_leds [2020/07/09 10:43] (current)
ba
Line 1: Line 1:
-====== Status LED ======+====== LEDs ====== 
 + 
 +===== Status LED =====
  
 The Status LED indicates the status of the sbRIO-9651 SOM boot process and Safe Mode state. The Status LED indicates the status of the sbRIO-9651 SOM boot process and Safe Mode state.
Line 10: Line 12:
 |Continuously flashing|The device has detected an **unrecoverable error**. see [[https://​knowledge.ni.com/​KnowledgeArticleDetails?​id=kA00Z0000019MUeSAM&​l=en-CH|knowledge base article]].| |Continuously flashing|The device has detected an **unrecoverable error**. see [[https://​knowledge.ni.com/​KnowledgeArticleDetails?​id=kA00Z0000019MUeSAM&​l=en-CH|knowledge base article]].|
 |Solid|The device is **currently booting**. This pattern also indicates when the [[reset|reset signal]] has been asserted for longer than five seconds.| |Solid|The device is **currently booting**. This pattern also indicates when the [[reset|reset signal]] has been asserted for longer than five seconds.|
 +
 +
 +===== Power LED =====
 +The power LED is lit when the Target is powered.\\
 +
 +
 +
 +
 +===== FPGA LED =====
 +This LED can be controlled from the FPGA aplication.\\
 +
 +
 +===== TempLED =====
 +The power LED is lit when the target gets too hot.\\
 +
 +===== HW revisions =====
 +
 +^hardware ​              ^ Status LED ^ Temp LED ^ Power LED ^ FPGA LED |
 +|ZSOM-Control V0.0..V1.1 | ✔          | ✔       | ✘        | ✘       |
 +|ZSOM-Control V1.2ff ​    | ✔          | ✔       | ✔        | ✔       |
 +|ZSOM-Mini V0.0..V1.0 ​   | ✔          | ✔       | ✘        | ✘       |
  • Last modified: 3 months ago